Cisco Connected Grid Multimode VDSL2, ADSL2/2+ and Symmetric High-Bitrate (G.SHDSL) DSL GRWIC for Cisco 2010 Connected Grid Router
Cisco Connected Grid Multimode VDSL2, ADSL2/2+ and Symmetric High-Bitrate (G.SHDSL) DSL GRWIC for Cisco 2010 Connected Grid Router
• Get a call from Sales
• Call Sales:
• 1-800-553-6387
• US/CAN | 5am-5pm PT
• Product / Technical Support
• Training & Certification
- Minimum Cisco IOS Release: 15.2(3)T
- Minimum Cisco IOS Technology Package: IP Base
- Product: GRWIC-VA-DSL-x
- Multimode DSL (VDSL2 and ADSL2/2+): Broadcom chipset • One RJ-11 VDSL2 interface • Dying gasp • IEEE 802.1q VLAN tagging • Independent DSL firmware loading VDSL2: • ITU G.993.2 (VDSL2) • 997 and 998 band plans • VDSL2 profiles: 8a, 8b, 8c, 8d, 12a, 12b, and 17a • U0 band support (25 to 276 kHz) • Ethernet packet transfer mode (PTM) based only on IEEE 802.3ah 64/65 octet encapsulation • Support for double-ended line testing (DELT) diagnostics mode • DSL Forum TR-067 compliance • Support for downstream speeds up to 100 Mbps in Ethernet PTM and up to 50 Mbps upstream ADSL2/2+: • ADSL over plain old telephone service (POTS) with Annex A and Annex B ITU G. 992.1 (ADSL), G.992.3 (ADSL2), and G.992.5 (ADSL2+) • ADSL over POTS with Annex M (extended upstream bandwidth) G.992.3 (ADSL2) and G.992.5 (ADSL2+) • Cisco Multimode VDSL2 and ADSL2/2+ EHWIC (EHWIC-VA-DSL-M) is optimized for power spectrum density (PSD) mask EU-64 M9 • Cisco Multimode VDSL2 and ADSL2/2+ EHWIC (EHWIC-VA-DSL-M) supports UK Annex M • G.994.1 ITU G.hs • Reach-extended ADSL2 (G.922.3) Annex L for increased performance on loop lengths greater than 16,000 feet from central office • T1.413 ANSI ADSL DMT issue two compliance • DSL Forum TR-067, and TR-100 conformity • Impulse noise protection (INP) and extended INP • Downstream power backoff (DPBO) • Asynchronous transfer mode (ATM) only
- DSLAM: VDSL2 over ISDN and Basic Telephone Service Line Card Chipset
- ZTE 9806: Broadcom
- Alcatel ISAM 7302: Ikanos
- Huawei 5603: Broadcom
- Alcatel ASAM7300: Broadcom
- ECI Hi-Focus 480: Infineon
- Ericsson ECN320: Broadcom
- Siemens HiX 5300: Infineon
- Ericsson EDA2.1: Broadcom
- Fujitsu FDX Hub 1000: Infineon
- Huawei MA5600: Conexant
- Lucent Stinger: Conexant
- Nokia D500: Globespan
- Product Number: Maximum Number of GRWIC slots
- CGR 2010: 4
- GRWIC-VA-DSL-A: Cisco Connected Grid VDSL2 and ADSL2/ADSL2+ GRWIC - Annex A
- GRWIC-VA-DSL-A=: Cisco Connected Grid VDSL2 and ADSL2/ADSL2+ GRWIC - Annex A, spare
- GRWIC-VA-DSL-B: Cisco Connected Grid VDSL2 and ADSL2/ADSL2+ GRWIC - Annex B
- GRWIC-VA-DSL-B=: Cisco Connected Grid VDSL2 and ADSL2/ADSL2+ GRWIC - Annex B, spare
- GRWIC-VA-DSL-M: Cisco Connected Grid VDSL2 and ADSL2/ADSL2+ GRWIC - Annex M
- GRWIC-VA-DSL-M=: Cisco Connected Grid VDSL2 and ADSL2/ADSL2+ GRWIC - Annex M, spare
- Symmetric High-Bitrate (G.SHDSL) DSL: Based on ITU Recommendation G.991.2 • Offers symmetrical WAN speeds up to 2.304 Mbps over a single copper pair and up to 4.608 Mbps over two copper pairs using ITU-T G.991.2 Annex A and Annex B • Offers symmetrical WAN speeds from 768 kbps to 5.696 Mbps over a single copper pair and from 1.536 to 11.392 Mbps over two copper pairs using ITU-T G.991.2 Annex F and Annex G • Supports Wetting Current (Section A.5.3.3 of G.991.2) • Supports G.SHDSL Annex A (U.S. signaling) and Annex B (European signaling) • Supports "dying gasp;" uses power status bit (section 7.1.2.5.3 of G.991.2) for signaling • Offers ability to configure multiple G.SHDSL GRWICs per Cisco CGR 2010 chassis • Offers extensive ATM class-of-service (CoS) and IP QoS support • Sustains up to eight permanent virtual circuits (PVCs) per GRWIC • Provides single RJ-11 connector
- Configuration Mode: Speed
- 2-wire (1 pair) Annex A and Annex B: 192 kbps to 2.304
- 4-wire (2 pair) Annex A and Annex B: 384 kbps to 4.608 Mbps
- 2-wire (1 pair) Annex F and Annex G: 768 kbps to 5.696 Mbps
- 4-wire (2-pair) Annex F and Annex G: 1.536 to 11.392 Mbps
- Alcatel ASAM 7300: SMLT-A
- ECI HiFocus SAM 480: STUC-16
- Lucent Stinger FS: STGR-LIM-SL-72, STGR-LIM-SL-48
- GRWIC-2SHDSL: Cisco Connected Grid G.SHDSL GRWIC
- GRWIC-2SHDSL=: Cisco Connected Grid G.SHDSL GRWIC, spare
- Feature: Specification
- Operating Temperature: 32º F to 104º F (0 to +40º C) continuous operating temperature range
- Shock and Vibration: 30G @11 ms
- Altitude: 10,000 ft (3,048 m); maximum operating temperature is de-rated with increasing altitude per IEEE1613a-2008
- Relative Humidity: 5 to 85 percent non-condensing
- Temperature: 32º F to 104º F (0 to +40º C) continuous operating temperature range
- Non-Operating Free-fall Drop: 4 in. (100 mm) per ENG-339611
- Operating Seismic Earthquake: IEC 61850-3 section 5.5
- Non-Operating Shock and Vibration: 40-50G (3.26 m/s minimum)
- Immunity: • EN61000-6-2 • EN61000-4-2 (ESD) • EN61000-4-3 (RF) • EN61000-4-4 (EFT) • EN61000-4-5 (SURGE) • EN61000-4-6 (CRF) • EN61000-4-11 (VDI) • EN 55024, CISPR 24 • EN50082-1
- Electromagnetic Compliance: • 47 CFR, Part 15 • ICES-003 Class A • EN55022 Class A • CISPR22 Class A • AS/NZS 3548 Class A • VCCI V-3 • CNS 13438 • EN 300-386
- Safety: • USA: UL 60950-1 • Canada: CAN/CSA C22.2 No. 60950-1 • Europe: EN 60950-1 • China: GB 60950-1 • Australia/New Zealand: AS/NZS 60950-1 • Rest of World: IEC 60950-1 • CSA certified to UL/CSA 60950-1, 2nd Ed. • CB report to IEC60950-1, 2nd Ed., covering all group differences and national deviations
- Telecommunication: • US: TIA-968-A • CA: CS-03 • EU: TBR1, 2, 4, 12, 13 • RTTE Directive • Australia: AS/ASIF S016, S038 • Japan: JATE
- Form Factor: Single-wide GRWIC, no slot restrictions
- Dimensions: 3.25 in. X 2.0 in. X 8.5 in. (W X H X D)
- Weight: 0.4 Kg (0.9 lb)
- itemListElement: Products & Services
- item: Products & Services
- position: 1
Write Your Own Review
secure transaction
Quick Shipping
Usually ships in 1 business day
easy return
Free shipping
Money back gaurantee
support content