Cisco CAB-ETH-40G-10M= OM3 MTP Fiber Cable, 10 m | 40G, Enterprise — CAB-ETH-40G-10M=

When 40G links need controlled reach and clean cable management, this Cisco OM3 MTP fiber cable fits the job. The 10 m length gives infrastructure teams room to route between racks, rows, or adjacent enclosures without forcing excess slack into the pathway. OM3 multimode construction is designed for high-speed short- to mid-reach optical transport, while the MTP interface supports high-density fiber connectivity in modern network builds. This cable is specified for FTW Netmod use and is commonly ordered in pairs, which aligns with deployment practices where matched components are required for a complete link. That matters in procurement and staging: you get a cable intended for the exact Cisco environment it was designed to serve, rather than a generic substitute that may complicate validation or support. For teams standardizing on Cisco optics and structured fiber runs, this part helps maintain consistency across the physical layer. It is a practical choice when link integrity, cable discipline, and vendor alignment are worth more than a lower-cost generic assembly. Ideal For Connect Cisco 40G modules across adjacent racks Build structured fiber runs in enterprise data center rows Stage matched cabling for FTW Netmod deployments Replace or expand high-density multimode links in Cisco environments Why This Product 1 Cisco-specific cable supports exact-fit deployment in Cisco optical environments 2 10 m length suits rack-to-rack routing better than short patch cords 3 MTP termination supports higher-density cabling than duplex connectors 4 OM3 multimode is aligned to 40G short-reach infrastructure needs